The Question is:
During an autogen the procedure stops in the getdata Phase with the following
%SYSTEM-F-OPCDEC, opcode reserved to Digital fault at PC=0000000000031330,
Can you tell me what can cause this message
The Answer is :
The OpenVMS Wizard is not familiar with this particular failure.
Please consider an upgrade to a more recent release, particularly
to a release with Current Version Support or Prior Version Support.
If you wish to debug AUTOGEN, you could define:
$ DEFINE AGEN$VERIFY 1
and attempt to determine which component image is failing. This
may then provide some insight into what is failing -- this could
be caused by a previously-unreported error, or by a bad block, a
file corruption, or otherwise.