 |
The Question is:
I'd like to send mail using telnet to another mail-server on AlphaServer 2100
5/300.
It is OK when I run the TELNET command in DCL COMMAND MOD, but when I write the
TELNET command to the file and then
$ZC(%SPAWN,"@"_commandfilename,,resultfilename) to run the file, It is not
excuted successfully, the result in the resultfile,"%SYSTEM-F-NO
PRIV, insufficient privilege or object protection violation" is written.
also when I wanna run the FTP or PONIX command in this way, although these can
be excuted, but the srceen is in the mod of FTP or PONIX, ignoring the next
command which is written after the FTP or PONIX command.
I hope you can help me.
It will also be appreciated if you give me the answer to my mailaccount.
Best Regards,
Mickel
The Answer is :
Please use the available SMTP mail capabilities directly.
Consider setting OpenVMS to use the remote node for mx-based
routing operations and/or for SMTP relay operations.
If you wish to execute commands on remote notes, rsh and rexec
are the more common choices.
If you wish to connect to a remote telnet server, well, write a
simple program or find an existing open-source program that fits
your needs.
If you wish to troubleshoot the NOPRIV error message -- assuming
that message is being directly produced by OpenVMS system services
and is not being synthesized by software -- please enable and use
the available OpenVMS security auditing and security alarms. The
use of privileges -- and privilege failures -- can be audited.
If you require direct assistance or email feedback, please contact
the support center directly; as stated in the prolog to asking a
question of the OpenVMS Wizard, the OpenVMS Wizard is not in a
position to provide such support services, nor timely feedback.
|
