The Question is:
After the creation of a robot on an Alha 4100 with the 'mcr sysman io connect
GKannn: /driver=SYS$GKDRIVER /NOADAPTER the device is on line.
But on installing the MRU software robote01014 the istallation of the software
On the ROBOT command I get a failure: 'device not responding'
ROBOT gkc401: is not responding: Robot Illegal request
I don't know what seems the problem
The Answer is :
It would appear that the SCSI configuration, the device configuration,
or the software has a problem, but the specifics of the problem will
require research. Check for a SCSI ID (address) collision, a SCSI
signal continuity or termination problem, and the other usual sorts
of SCSI errors that can arise.
Then please contact the Compaq Customer Support Center.