 |
The Question is:
I have an ALPHA Server 400 with VMS 6.2 on DKA0. For testing purposes I want to
have 7.2-1 on the 2nd. disk, DKA100. Seems simple enough. I upgraded the
firmware, installed 7.2-1 and DECnet IV and TCPIP 5.0. Now the tricky part.
6.2 works fine networking-
wise as regards TCP/IP. 7.2 can ping itself and telnet to itself, but it can't
see any other system nor can any system see it. At the hub, the LED is never
lit when booted to 7.2 as it is when booted to 6.2 and no matter what I do I
can't get a device EWA
1 as I get in 6.2. Here's what I have in 7.2:
DIGITAL TCP/IP Services for OpenVMS Alpha Version V5.0A
on a AlphaServer 400 4/166 running OpenVMS V7.2-1
Device Device Error
Name Status Count
EWA0: Online 0
EWA2: Online 0
EWA3: Online 0
EWA4: Online 0
EWA5: Online 0
and what I have in 6.2:
DEC TCP/IP Services for OpenVMS AXP Version V3.3
on a AlphaServer 400 4/166 running OpenVMS V6.2
Device Device Error
Name Status Count
EWA0: Online 0
EWA1: Online 0
EWA2: Online 0
EWA3: Online 0
Can you shed some light on my problem? Thanks!
The Answer is :
The various aspects of the TCP/IP Services V5.0A network configuration
-- the licenses, the setup, the startup, the databases, the choice of
services enabled, the console network negotiation selection, the IP host
address and network mask selected, the network gateway, etc -- would be
the initial suspects.
If you are unable to determine the particular cause, please contact the
Compaq Customer Support Center for assistance in troubleshooting this.
|
