HP OpenVMS Systems

ask the wizard
Content starts here

Changing DECserver characteristics?

» close window

The Question is:

I am having problems setting up a DECserver 250 and 200.  I tried to set the
terminal server in local mode on any of the ports and was unable to do this.
I received an error message of 708 when trying to set the port to a local
state.  Is there something
 I am doing incorrectly.  Please advise me of the correct proceedure of
adding a vt terminal to a terminal server.
Thanks in advance.
Alan Riedford
System Administrator

The Answer is :

  One potential approach involves the use of the DEFINE command available on
  various DECserver devices, and a reboot.  If that fails or is not available
  on the particular DECserver software version loaded, please contact the
  Compaq Customer Support center for assistance -- information on your local
  configuration and firmware version, as well as the commands and the error
  messages, as well as any remote host access operations that might be in
  place, will be required.

answer written or last revised on ( 19-AUG-1999 )

» close window