you modified MODPARAMS.DAT to enable or modify shadowing parameters
(see Section 7.4), or if you removed hardcoded BAP system parameters
(see Section 7.5), then run AUTOGEN and reboot the system by performing the following
steps. This makes the changes take effect.
AUTOGEN by entering the following command:
$ @SYS$UPDATE:AUTOGEN GETDATA TESTFILES NOFEEDBACK
AUTOGEN completes, display or print the SYS$SYSTEM:AGEN$PARAMS.REPORT
file and review it. This file lists changes being made to SYSGEN
parameters or changes that AUTOGEN wanted to make but could not because
of a hardcoded or maximum value that was specified in MODPARAMS.DAT.
other changes need to be made to MODPARAMS.DAT based on a review of
the AGEN$PARAMS.REPORT file, make them now and then resume at step
you are satisfied with the parameter settings, enter the following
$ @SYS$UPDATE:AUTOGEN GENPARAMS SETPARAMS NOFEEDBACK
This command makes the parameter changes permanent
so that they are used on subsequent reboots.
the system by entering the following command:
For more information about AUTOGEN, see HP OpenVMS System Management Utilities Reference Manual: A-L.